Product Manual

Page 6
INSTRUCTIONS (CONTINUED)
Fig. 14
Point the Threaded Barrel down into the
tire as shown in Fig. 14. Use the channel
on the nozzle to grab the rim. Lean for-
ward slightly to hold it in position. Gather
your footing, hold one hand onto the
Cheetah Handle and the other on the
Manifold Valve Lever.
Fully turn the Lever releasing all the air
into the tire and seating the bead.
Remove Whip Hose Locking Chuck from
valve stem and replace valve stem core.
Make sure the valve core is firmly tightened in-place and proceed to inflate the tire to
manufacturers tire pressure requirements.
Check for leaks. If none are present place valve stem cap on valve stem and wipe
off excess lubricant. If there are leaks, address them and repeat the process.
It isn’t unusual taking several attempts seating a tire bead until an operator becomes
familiar with this process. Once some experience is gained the success rate will
increase greatly.
One important factor is to aim the Threaded Barrel into the tire directly. Generally
speaking this is at about 45 degrees but you’ll note it can vary from one tire to an-
other.
MAGNUM1 - Optional
Difficult wheels? Use the
Magnum1 in Fig. 15.
Remove Threaded Barrel
and replace it with the
Magnum1.
Tighten it and use just like
the Threaded Barrel.
Fig. 15
The arced tube has
holes in it for direct
air flow into the tire
TI-87 Shelf
(Wall Mounted)