Product Manual

Page 5
Connect air line to the Whip Hose and open valve inlet. Remember, you will be clos-
ing the Whip Hose valve shortly after the bead is seated.
Close Discharge Valve handle (Fig. 12) on tank. Connect air line to the Fill Valve.
Make sure the valve is open. Close valve once it’s filled and disconnect the air line.
Note: It’s not always necessary to fill the tank to capacity.
Fig. 12
Closed
Open
Fig. 11
Firmly hold Cheetah tank as shown in Fig. 13.
The Cheetah tank blasts air at a high rate so
body positioning is important.
Just as important is footwear, eyewear and
proper noise protection.
Gloves are recommended and you must keep
your hands and fingers free from the Bead
Seating area.
Do not wear loose clothing.
With experience you’ll recognize filling the tank
to capacity isn’t always necessary. Some tires
can be seated with as little as 20 PSI. Most,
when using the proper technique, Tri-stand
and lubricant can be seated using 40-60 PSI.
Fig. 13
Now you can attempt
to seat the tire bead
and rim.
Keep in mind once
you seat the bead
you’ll need to be
aware of how fast air
is entering the tire
through the Whip
Hose. At some point
you will need to close
the valve to stop filling
the tire.