Product Manual

TM
Set-Up
Verify receiving all the parts described in this instruction. If necessary assemble as
shown in Fig. 3 thru Fig. 8.
INSTRUCTIONS
Do not use the CH-5 or CH-5AL CHEETAH for anything but seating tire beads.
Page 3
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
To install the Discharge Valve and Threaded Barrel use a large pipe wrench or a
large socket wrench. Tighten so air doesn’t weep out of the fitting. Use Teflon tape
where applicable.
A helpful hint: To hold tank in-place slide it on the fork of a forklift (through the han-
dle) and tighten the Threaded Barrel or Discharge Valve if they come loose. Put
some air in the tank and use soapy water to check fitting connections for air leaks.
Tighten them as necessary. When tightening make sure Nipple tightens too.
This end up
In Fig. 6 use a screwdriver and a hammer to tighten pipe nut. Make sure the end of
the Threaded Barrel as in Fig. 5 is up.
If the Pop-off Valve in Fig. 7 comes loose tighten it as shown.
Note position of
Discharge
Valve handle.