Product Manual

Page 5
Fig. 8
Mounting the
tire uses the “flat-end” of the Mongoose Tire Tool (see Fig. 8). While applying pressure to
the low side of the tire (always facing the operator) place the ball-end between rim and bead. With the
flat side against the center post rotate the tool full circle for both bottom and top beads.
Remember to use lubrication on the rim and tire bead.
Mount - Demount with optional accessories
Demount deflated tire using the "rod end" of the Mongoose Tire Tool (see Fig. 7). The ball end is
pushed under the top bead and rested on the rim as illustrated. While holding the Mongoose Tool
against the center post with one hand, and lifting up on the tire with the other, rotate the tool full circle.
Demount the bottom bead the same way.
Vary the angle of the Mongoose Tire Tool against the center post can achieve better results for each
user based on the different rim or tire sizes and the shapes of each.
Fig. 9
PN 12489 Demount
To protect chrome or aluminum rims from
tool scrapes use this handy plastic
accessory with the regu
lar size Mongoose
Tire Tool or the the Mini Mongoose Tire
Tool.
Hold the Demount tab on the Mongoose
Tire Tool.
Push down and into the tire
flange/bead
area (see Fig. 9).