Product Manual

CH-22 MULTI-TIRE CHANGER
INSTRUCTION-MOUNTING/DEMOUNTING
Demount the bottom bead in the same manner as above.
The angle of the mongoose tool against the center post can
be varied to accommodate operator height or rim depth
withoutaffectingeaseofoperation.
Mounting the tire uses the "flat-end" of the Mongoose tire
tool. While applying pressure to the low side of the tire
(always facing the operator), place the ball-end between
the rim and bead. With the flat side against the center
postrotatethetoolfullcircleforbothbottomandtopbeads.
3
EGAP
3.3
Demount deflated tire using the "rod-end" of the Mongoose
tire tool. The ball end is pushed under the top bead and
restedontherimasillustrated. Whileholdingthemongoose
against the center post with one hand, and lifting up on the
tirewiththeother,rotatethetoolfullcircle.
3.1
3.2
IMPORTANT -ALWAYS LUBE THE TIRE!
3451 South 40th Street • Phoenix, Arizona 85040 • Toll Free 800.223.4540 • Arizona 602.437.5020 • Fax [phone]
SECTION THREE
It is important to use a good tire lubricant while mounting and dismounting,
(Lube & Rust Inhibitor part #22.11007),and be sure that the bead is in the
drop center of the rim during this process. In the unlikely event that you
encounter difficulty in rotating the Mongoose easily use a small tire iron
(#22.3877) to spoon the tire around at the point of greatest resistance.
C
M
Y
CM
MY
CY
CMY
K
Judy - CH-22 Ops Instr.pdf 5/4/2011 12:47:32 PM