Product Manual

ManualsBrandsTSI ManualsAutomotivePakPress Portable Wheel Stud Remover and Installer

PAK PRESS

PORTABLE WHEEL STUD REMOVER AND INSTALLER

TSI Model #PP-10-PF

(Includes Frame, Cylinder and Adapters ONLY)

TSI Model #PP-10-PPK

(Includes Frame, Cylinder, Air Pump, 6 Ft Hose, T-Adapter & Gauge)

READ INSTRUCTIONS THOROUGHLY BEFORE OPERATING

OPERATING INSTRUCTIONS

800.223.4540

3451 S. 40th Street

Phoenix, AZ 85040

602.437.5020

www.tssissg.com

info@tsissg.com

Fax 602.437.5025

MADE IN USA

MAR 24, 2009

Summary of content (4 pages)

PAGE 1
OPERATING INSTRUCTIONS PAK PRESS PORTABLE WHEEL STUD REMOVER AND INSTALLER TSI Model #PP-10-PF (Includes Frame, Cylinder and Adapters ONLY) TSI Model #PP-10-PPK (Includes Frame, Cylinder, Air Pump, 6 Ft Hose, T-Adapter & Gauge) READ INSTRUCTIONS THOROUGHLY BEFORE OPERATING 800.223.4540 3451 S. 40th Street Phoenix, AZ 85040 602.437.5020 www.tssissg.com info@tsissg.com Fax 602.437.
PAGE 2
INCLUDED ADAPTERS: PAK TOOL #1 ADAPTER #101 TSI #11637 PAK TOOL #2 ADAPTER #102 TSI #11638 SPECIAL ORDER ADAPTERS: OPTION PAK TOOL #3 ADAPTER #103 TSI #11766 PAK TOOL #3 ADAPTER #103 TSI #11639 PAK TOOL #4 ADAPTER #104 TSI #11640 PAK TOOL #5 ADAPTER #105 TSI #11641 FOOT PEDAL PIVOTS UP AND DOWN TO APPLY OR RELIEVE CYLINDER PRESSURE OPTION PAK TOOL #4 ADAPTER #104 TSI #11767 (Not included with PP-10-PF or PP-10-PPK) SAFETY INSTRUCTIONS SAFETY GLASSES ARE REQUIRED FOR OPERATION! Before each use vis
PAGE 3
OPERATING INSTRUCTIONS STUD REMOVAL Place Pak Tool #1 firmly into threaded end of cylinder ram. Slide roll-pin from Pak Tool #4 into pinhole located at the open end of the Cylinder Frame. (Fig A) With adapters in place hold frame unit over hub and center adapters over stud to be removed. With Foot Pedal on Pump apply hydraulic pressure until both adapters make contact against the stud STOP! Center and align PAK-PRESS unit with adapters prior to applying pressure from the hydraulic pump.
PAGE 4
STUD INSTALLATION Place Pak Tool #3 firmly into threaded end of cylinder ram. (FIG C) (Note: Pak Tool #4 is not used to install studs.) It is recommended that you apply an anti-cease or lubricant on the shoulder of the stud. Put new stud in position to be pressed in Hub. Position Cylinder Frame and adapter over the new Stud on Hub. Apply hydraulic pressure using the Foot Pedal on Pump. When Pak Tool #3 comes into contact with Hub, much of the stud will be inside Pak Tool #3.