OPERATION, INSTALLATION AND MAINTENANCE MANUAL Flush Mount Enclosure Suitable for H EAT STR IP C las s ic w ith Re mo te & H EAT STR IP C las s ic w ith Re mo te & Ap p (THH-AR Range & THH-AA)
Flush Mount Enclosure MARCH 23 Rev 2 The Flush Mount Enclosure is an ideal way to neatly install the HEATSTRIP into a ceiling. They are available for all HEATSTRIP® Classic with Remote models and are supplied as a one-piece unit suitable for mounting individual heaters. Flush mounting can be used with any building grade ceiling materials. An ideal mounting height is 2.3m-2.5m, with a maximum ceiling height of 2.7m in a fully enclosed outdoor environment.
Flush Mount Enclosure Dimensions VIEW FROM UNDERNEATH 3 VIEW FROM TOP PART No MODEL “A” (mm) “B” (mm) “C” (mm) THHAC-013 THH2400AR 1526 1468 1464 THHAC-014 THH3200AR 1936 1878 1874
Installation Location The diagrams below and on the following page give the minimum clearances required for the installation of the Flush Mount Enclosure. It is imperative that all cables, insulation and other materials are kept clear of the back and the sides of the Flush Mount Enclosure. The enclosure has a number of openings for ventilation and air movement into the ceiling space; these openings must not be covered.
Installation Clearance Dimensions The diagrams below give the minimum installation clearances of the Flush Mount Enclosure. It is recommended to use only the provided holes in the ends of the enclosure for mounting. • • • The minimum distance between the back of the enclosure and any building material is 50mm. The minimum distance between the sides of the enclosure and any support structure is 50mm. The minimum distance between adjacent enclosures is 200mm.
Installation Instructions Ensure all minimum clearance requirements are met and the materials used are compliant to your local building codes. Before installing the FME, ensure the site to be fixed is fully prepared with the hole cut the correct size and the mounting points securely in place. MODEL “D” DISTANCE FROM END TO BRACKET (mm) THH2400AR 388 THH3200AR 443 HEATER BRACKET x2 STEP 1: Attach the brackets to the rear of the heater.
Safety In operation, this heater is VERY HOT— do not touch any part of the heater while it is turned on. Do not touch any part until 30 minutes after it is turned off. This appliance is not intended for use by persons (including children) with reduced physical, sensory or intellectual capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Warranty Terms & Conditions The below Warranty Terms and Conditions apply for New Zealand and Australia only. For international warranty please refer to international warranty terms and conditions. Thermofilm warrants to the original owner that the FLUSH MOUNT ENCLOSURE product will be free from defects in materials and workmanship for a period of 12 months from the date of purchase in accordance with the following warranty terms and conditions.
