Tus neeg siv phau ntawv

1. Check if the electric socket is providing 220Vac power. If not please make sure it does
before moving on to the next step.
2. Install or hang the unit in a location where emergency illumination is required.
Make sure the unit is installed securely to prevent any possible accidents.
3. Turn the ON/OFF switch to the on position for both lamps. Both lamps should turn on.
4. Plug the unit into the electric socket which provides a 220VAC 50Hz electrical supply,
the lamps should turn off automatically.
5. After receiving a 220VAC power supply there should be the following indications.
5.1 LED AC Power will turn on indicating the unit is receiving a 220Vac power supply.
5.2 LED Charge should turn on indicating that the battery is charging.
5.3 LED FULL CHARGE will turn off when the battery is fully charged.
6. To test the operation of the unit.
6.1 Pressing the TEST switch on the unit the emergency lamps should turn on.
The lamps should turn off when the switch is released.
7. During power outages the emergency lamps will turn on automatically.
When power returns the lamps will automatically turn off and begin recharging its
battery.
NOTE : When the lamps turn on automatically, they can be switched off to conserve
battery power by using the Off switch. To turn the lamp on the On switches on the unit
can be used (there are independent switches for each lamp to turn them on separately,
only one lamp can be used to extend the runtime of the battery).
1. The unit should be installed indoors away from direct sunlight and rain or moisture.
2. The unit should be stored in temperatures under 25 Degree Celsius and the battery
should be charged every 3 months to maintain its operational life.
Installation and Operation
Important Note on Using the Unit