Tus neeg siv phau ntawv

Installation and Operation
1. Check if the power socket is providing power before moving on to the next step.
2. Check that the load electrical wire is in good working order. If so, connect it to the
Terminal Output and screw tightly to prevent any electrical sparks that could cause fire.
3. connecting to load wiring to the output terminal inside the unit (check for any short-
circuits before connecting)
4. Set the DC.Circuit Breaker to ON. The DC Volt Meter should display the Voltage of the
battery and the connected lamps should illuminate.
5. Connect the 220 Volt Line into the circuit box.
6. After installation and a 220Vac power supply is provided the unit should show the
following indicators.
- The LED AC Power will turn on to indicate the unit is receiving a 220Vac power supply.
- The LED CHARGE will show if the unit’s battery is charging.
- The LED Full will show once the battery is fully charged.
- The connected lamps should turn off automatically.
7. Testing the unit’s operation.
- Pressing the TEST switch on the unit should turn on the emergency light.
- Release the TEST switch and the light should turn back off.
- Turn off the Main 220 Volt Line, the emergency lights should turn on. If the Main 220 Volt
Line is turned on the emergency light should turn off automatically.
8. During power outages the emergency light should automatically turn on and will turn on
automatically and start charging the battery once power is restored.
How to correctly connect the INPUT 220Vac. and OUTPUT 12Vdc, 24Vdc