User's Manual

- 30 -
4. The printer will beep sound twice later, then release the FEED button ( ) when the
indicator becomes and blinking.
5. Printer will calibrate the sensor and print out the internal settings, then enter the dump
mode.
Note: Turn off/on the power or press FEED button to resume printer from dump mode
to normal printing mode. Please refer to sections 4.3 and 4.4 for more details of
self-test and dump mode.
 The LEDs will be changed as following figures:
Beep sound twice Æ (5 blinks) Æ (5 blinks) Æ (5 blinks) Æ Turn
on the printer
4.1.3 Printer Initialization
Printer initialization is used to clear DRAM and restore printer settings to defaults.
Printer initialization is activated by the following procedures.
1. Turn off the printer power switch.
2. Hold on the FEED button ( ) then turn on the power switch ( ).
3. Release the power switch ( ) when LED color turn on amber.
Note: In this moment, you should still hold on the FEED button.
4. The printer will beep sound twice later, then release the FEED button ( ) when the
indicator becomes and blinking.
5. Printer will restore printer settings to defaults.
Note: Please refer to section 4.5 for printer defaults.
 The LEDs will be changed as following figures:
Beep sound twice Æ (5 blinks) Æ (5 blinks) Æ (5 blinks) Æ Turn
on the printer