Data Sheet

Model: FSC-BT826HC
Contains FCC ID：VTV
-FSCBT826HC
The host OEM user manual must also contain clear instructions on how end users canfind and/or access
the module and the FCC ID and ISED.
Model: FSC-BT826HC
Contains FCC ID： VTV-FS
CBT826HC
OEM Statement
a. The module manufacturer must show how compliance can be demonstrated only for
specific host or hosts
b. The module manufacturer must limit the applicable operating conditions in which t
transmitter will be used, and
c. The module manufacturer must disclose that only the module grantee can make the te
evaluation that the module is compliant in the host. When the module grantee either refuses to
make this evaluation, or does not think it is necessary, the module certification is rendered
invalid for use in the host, and the host manufacturer has no choice other than to use a different
module, or take responsibility (§ 2.929) and obtain a new FCC ID for the product.
d. The module manufacturer must provide the host manufacturer with the followi
requirements:
i. The host manufacturer is responsible for additional testing to verify compliance as
composite system. When testing the host device for compliance with Part 15 Subpart B, the host
manufacturer is required to show compliance with Part 15 Subpart B while the transmitter
module(s) are installed and operating. The modules should be transmitting and the evaluation
should confirm that the module’s intentional emissions are compliant (i.e. fundamental and out of
band emissions).