User Manual

WIFI MODULE INSTALLATION GUIDE

WIFI-EM01, WIFI-EM101

Installing the WiFi Device to the Printer

Please follow the steps below to install the WiFi device.

1. Turn off the printer power.

2. Plug in the WiFi device into the RS-232 port.

3. Fasten the device by two screws.

Setting the Communication Settings

For industrial printer, the RS-232 communication parameters can be configured from the LCD control panel by

the following procedures.

1. Turn on the printer power.

2. Enter the main menu.

3. Select Serial Comm. Option.

4. Make sure the communication parameters are set to 115200 bps baud rate, None parity, 8 data bits, 1

stop bit.

For desktop printer models, the RS-232 communication parameters can be setup following command

Syntax:

SET COM1 115, N, 8, 1

P/N: 39-0000-00LF

Baud Rate -- Parity -- Data Bite -- Stop Bits -- Exit

Serial Comm.

WiFi device

Screw

LED indicator

Note:

This RS-232 interface of WiFi device is used with the

printer only.

PAGE 1
WIFI MODULE INSTALLATION GUIDE WIFI-EM01, WIFI-EM101 Installing the WiFi Device to the Printer Please follow the steps below to install the WiFi device. 1. Turn off the printer power. 2. Plug in the WiFi device into the RS-232 port. 3. Fasten the device by two screws. Note: This RS-232 interface of WiFi device is used with the printer only.
PAGE 2
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.