User Manual

- 27 -

5.5 Setting Bluetooth by Diagnostic Tool (Optional)

1. Make sure the media is installed ready and media cover is closed. (Please refer to

section 3.4)

2. Turn on the printer power switch.

3. Open Diagnostic tool and set interface. (The default setting is USB)

The default interface setting is USB

interface. If USB interface is

connected with printer, no other

settings need to be changed in the

interface field.

4. Select “Wireless” tab and “Built-in wireless module” item.

5. Enter the new BT Local Name or BT PIN Code in the editor.

6. Press “Set” button to set the new BT name or BT PIN code of the printer.

7. Press “Get” button to get back the settings. Make sure the Bluetooth module settings

are set properly.

Note:

* The printer connects with the computer via USB cable or RS-232 cable, which are option.

* Diagnostic tool higher than V1.50 and the firmware higher than V1.22 can support this

function.