User Manual

- 19 -
4.3 Printer Initialization
Printer initialization is used to clear DRAM and restore printer settings to defaults.
Printer initialization is activated by the following procedures.
1. Turn off the power switch.
2. Hold on the FEED button( ) then turn on the power switch.
3. Release the FEED button( ) when the indicator becomes and blinking.
(Any green will do during the 5 blinks).
n The LEDs will be changed as following:
(amber) à (5 blinks) à (5 blinks) à (5
blinks) à (solid green)
Printer configuration will be restored to defaults as below after initialization.
Parameter
Default setting
Speed 50.8 mm/sec (2 ips)
Density 8
Media Width 2.83” (72 mm)
Media Height 4” (101.5 mm)
Sensor Type Black mark sensor (As paper end sensor)
Black Mark Setting As paper end sensor
Print Direction 0
Reference Point 0,0 (upper left corner)