User Manual

6.4 Setting by Diagnostic Tool

1. Make sure the media is installed ready and media cover is closed. (Please refer to

section 3.4)

2. Turn on the printer power switch.

3. Open Diagnostic tool and set interface. (The default setting is USB)

The default interface setting is

USB interface. If USB interface

is connected with printer, no

other settings need to be

changed in the interface field.

4. Select “Wireless” tab and “Built-in wireless module” item.

5. Enter and select the new Wireless settings in the editor.

6. Press “Set” button to set the new settings to the printer.

7. Press “Get” button to make sure Wireless is set properly.

Note:

Diagnostic tool higher than V1.50 and the firmware higher than V1.22 can support this

function.