User Manual

24
 Dump mode
Printer will enter dump mode after printing printer configuration. In the dump mode,
all characters will be printed in 2 columns as following. The left side characters are
received from your system and right side data are the corresponding hexadecimal
value of the characters. It allows users or engineers to verify and debug the
program.
Note:
1. Dump mode requires 3” wide paper width.
2. Turn off / on the power to resume printer for normal printing.
5.3 Printer Initialization
Printer initialization is used to clear DRAM and restore printer settings to defaults.
Printer initialization is activated by the following procedures.
1. Turn off the power switch.
2. Hold on the button then turn on the power switch.
3. Release the button when the indicator becomes and blinking. (Any
green will do during the 5 blinks).
 The LEDs will be changed as following:
(amber)  (5 blinks)  (5 blinks) 
(5 blinks)  (solid green)
ASCII Data
Hex decimal data related to left
column of ASCII data