User Manual

5. Power-on Utilities

There are three power-on utilities to set up and test printer hardware. These utilities are

activated by pressing FEED button then turning on the printer power simultaneously and

release the button at different positions of LED indicator.

Please follow the steps below for different power-on utilities.

1. Turn off the printer power switch.

2. Hold on the button then turn on the power switch.

3. Release the button when LED indicates with different positions for different functions.

Power on utilities

The positions of LED light will be changed as following pattern:

LED

Functions

(Solid)

(5 blinks)

(Solid green)

1. Black mark sensor

calibration

Release

2. Self-test and enter dump

mode

Release

3. Printer initialization

Release

5.1 Black Mark Sensor Calibration

Black mark sensor sensitivity should be calibrated at the following conditions:

1. A brand new printer

2. Change media roll

3. Printer initialization

Please follow the steps below to calibrate the black mark sensor.

1. Turn off the power switch.

2. Hold on the button then turn on the power switch.

3. Release the button when the indicator becomes and blinking. (Any

green will do during the 5 blinks)