Instructions / Assembly
12
Cleaning and storage
If there are stains on the surface of the scooter, use a soft cloth
to dip in a small amount of water to wipe; If there are stains that
are difficult to clean, smear them with toothpaste and brush
them repeatedly, then clean them with a damp cloth. If the
plastic parts of the body are scratched, use sandpaper or other
abrasive materials to polish them.
Attention:
Do not use alcohol, gasoline, kerosene or other corrosive and
volatile chemical solvents to clean, otherwise it will seriously
damage the appearance and internal structure of the car body.
It is forbidden to use pressure water gun to spray and wash.
Ensure that the scooter is o and the charging port rubber cover
is tightly fastened during cleaning, otherwise electric shock or
serious failure may occur due to internal water inflow. When
not in use, store in a dry and cool place indoors. Avoid outdoor
storage for a long time. Long-term sun exposure, overheating
and cold outdoor environment will accelerate the appearance
and tire aging of the scooter, and reduce the service life of the
scooter and battery pack.
Tire ination maintenance
This product tire is vacuum tire, when the tire height sinks 20%-
30%, need to inate. The recommended tire pressure is 45-50
psi after ination, and the tire should be inated at least once
every 2-3 months. Regular ination and cleaning of tire surface
debris can prolong the service life of the tire.
Battery maintenance
1. Do not use battery packs of other models or brands, or else
there may be safety risks.
2. It is strictly forbidden to disassemble, squeeze, or puncture
this product; it is forbidden to throw this product into water, re
(including heat sources such as stove, heater, etc.) or expose it
to an environment with a temperature higher than 50 °C.
3. Water entering the battery may cause damage to the
internal circuit, and there is a risk of re or even explosion; if