Indoor Electric Space Heater MODEL: KPT-173ND 1
After-Sales Service Thank you for supporting our product. We provide a 12-month warranty to every customer. For any questions or concerns, please contact us at below email along with the model number: KPT-173ND and your order number, we will give you a satisfactory solution: support@trustechproducts.com Or scan the QR code for 24-hour online after-sales service.
CATALOGUE After-Sales Service.............................................................................................................. 2 Important Safety Instructions..............................................................................................4 Safety Protection Feature................................................................................................... 5 Overheating Protection................................................................................................
Important Safety Instructions Please read this guidance carefully before using your fan heater, so that you can use it correctly. Please keep well with this guidance. When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons. WARNING: POTENTIAL ELECTRICAL HAZARD IF NOT ADHERED TO. 1. This heater must be plugged into a 120V, 15amp (or more) circuit of its own. Do not plug anything else into the same circuit.
15. Leave at least 3 ft. of unobstructed space to the front and rear of the heater to allow for maximum heat, air, and ventilation flow. 16. Inner parts of the heater might slightly hot arcing or sparking. Do not use it in areas where gasoline, paint, or flammable liquids are used or stored, nor use flammable solvents to clean the heater. Keep the heater dry at all times. 17. Use this heater only as described in this manual.
Cautions WARNING: TO PREVENT ELECTRICAL SHOCK, MATCH THE WIDE BLADE OF THE PLUG TO THE WIDE SLOT OF THE RECEPTACLE AND FULLY INSERT. WARNING: It is normal for the power cord to get hot at work. However, a poor connection or loose fit between the outlet and the plug may cause overheating of the plug. If this occurs, try inserting the plug into a different outlet. Contact a qualified electrician to inspect the original outlet for damage.
Using Methods KPT-173ND Turn on the power switch in the back first， “O”= OFF，“—”ON； 1. Turn on the power switch in the back, LED display “--”, the appliance is standby; See picture 1.1 2. Press “ ”as follows: ON (only Fan working), LED display Environment temperature(default is ℉ after the power cut off); OFF(Fan will keep working for 30 seconds when shutdown the appliance after heating)；See picture 2.1 3. Press “ 3.1-3.2 ”, low heat(1000W), high heat(1500W), FAN working, See picture 5.
Maintenance 1. Please make sure the plug should be pulled out BEFORE cleaning the heater. 2. Strictly prohibit washing the radiator by water, it can be cleaned by a piece of soft damp cloth with a little neutral detergent. Please do not use other solvents like gasoline. 3. The fan heater must be used or stored after cooled and dried completely. 4. If stop using the heater, please pull out the plug from the socket, and store it in the dry place with a rust-proof polybag, original packing is favored.
