Technical data

WIRELESS POWER SYSTEM 320SY

3 Installation

This chapter describes how you must program and place your system. Important

aspects are indicated by means of “ Note: ....”.

3.1 Switches

Note: Check the capacity of the device you want to connect, you can switch a

maximum of 3500 Watt with the WIRELESS POWER SYSTEM 320SY

switch.

Note: The WIRELESS POWER REMOTE CONTROL 300RC only operates

with a remote control from the Trust power 300 range.

1. Set your home code (A t/m P) on the WIRELESS POWER SYSTEM 320SY

switch by means of the rotation switch on the back. Select a home code which

is not in use by other devices in your vicinity but which is the same as that of

the remote control you are using. See figure 1.

2. Next, set the selected device code (1 through 16) with the second rotation

switch. See figure 2.

3. Plug the switch into the power outlet.

4. Next, plug the device (a coffee maker, for example) you want to operate by

remote control into the switch. See figure 3.

5. If the device has its own on / off switch, switch it on.

Now you can switch the device on and off if you have entered the correct channel

settings on your remote control. When the red light goes on, it is off and when the

green light goes on it is on.

3.2 Remote control

Before you can operate your devices with the WIRELESS POWER SYSTEM 320SY

remote control, the devices must first be connected to the Trust WIRELESS POWER

SYSTEM 320SY switches or other receivers of the Trust power 300 series.

3.2.1 Inserting the batteries

1. Remove the battery compartment cover. See figure 4.

2. Insert the 23A 12V (B) in the compartment (C) with the “+” pole to the “+” pole

of the remote control and the “-“ pole to the “-“ pole of the switch. See figure 4.

3. Replace the battery compartment cover.

Note: Remove the battery if you do not use the remote control for an

extended period.