Product Manual

6
Reset
Resets the settings of the remote control to the factory set-
tings when pressed using a ballpoint pen, for example. Setup
symbol flashes.
Resend
The previous settings are resent.
Setup
Tune the remote control to the air conditioning system that is
going to be operated. Settings set to “Circulated air”, fan level
low, no timer set.
IR receiver and manual on / off
There is an additional pushbutton on the IR receiver (m), with
which the unit can also be switched on and off without the
remote control (e.g. with a ballpoint pen).
If the unit is switched on using this pushbutton, the system is au-
tomatically reset to the factory settings (automatic mode 22 °C).
IR receiver / function indicator
LED 3
LED 2
LED 1
m
Fig. 2
LED 1 blue – illuminated – (cooling mode)
LED 1 blue – flashing – (cooling mode compressor start-up)
LED 2 yellow – illuminated – (heating mode)
LED 2 yellow – flashing – (heating mode compressor start-up)
LED 3 red – flashing – (data are being transmitted)
LED 3 red – illuminated – (fault)
Red LED illuminates
The device is indicating a fault. Switch device off, wait for a
short time and switch on again. If the red LED continues to
illuminate, please contact the Truma Service Centre.
Air Distribution
Right / left
There are two individually adjustable air outlets at the front
and rear.
Front / rear
The air flow can be metered between the front and rear areas
of the vehicle.
Ceiling / floor
The air flow can be directed from the ceiling to the floor.
right / left right / left
right / left right / left
IR receiver /
function indicator
front / rear
ceiling /
floor
ceiling /
floor
front
front
rearrear
Fig. 3
IR remote control battery change
Only use micro-batteries that will not leak, type LR 3, AM4,
AAA, MN 2400 (1.5 V).
The battery compartment is on the back of the remote control.
When inserting new batteries, make sure
the positive / negative terminals are con-
nected correctly.
Empty, used batteries can leak
and damage the remote control!
Remove the batteries if the remote con-
trol is not being used for a long period of
time.
Fig. 4
No warranty given for damage caused by leaking
batteries.
Before scrapping the remote control, always remove the bat-
teries and dispose of them properly.
The tuning between the remote control and the air con-
ditioning system is retained if the batteries are removed.
Maintenance
Carry out filter changes depending on the amount of use, but
at least every 12 months. Never operate the air conditioning
system without a filter. This can lead to loss of power. Keep
the air inlets / outlets and the condensation traps free of ob-
structions such as leaves at all times. The air conditioning sys-
tem should only be cleaned with a soft, damp cloth.
Disposal
The device must be disposed of in line with the administra-
tive regulations of the respective country in which it is used.
National regulations and laws (in Germany, for example, the
End-of-life Vehicle Regulation) must be observed.
In other countries, the relevant regulations must be observed.