Product Manual

Cut-out installation 400 x 400

For optimum sealing we recommend the use of the sealing

frame that is available as accessory (part no. 40091-19000).

For installation with a sealing frame, please refer to the instal-

lation instructions provided with the sealing frame.

When installing the device in vehicles with an existing roof

hatch, the cut-out must measure 400x400mm.

Remove existing roof hatch (make cut-out bigger if necessary).

Remove sealant residue and unevenness.

Fill in screw holes with body sealant.

4 0 0

Fig. 17

For the other installation steps, please refer to “Preparation

for power cable connection”.

Installation with new cut-out

For vehicles without an existing cut-out:

required cut-out 350 x 380 mm.

Place template on installation location on vehicle, mark cutout

(350 x 380 mm) and cut it out.

Mark the 4 holes (10 mm) for bracket attachment and drill

holes in roof.

380

350

Fig. 18