User's Manual

 8/14

5 . Memory Functions
After measurement,the last set of measured values will be saved automatically after
measurement when the unit is turned off by pressing ““START/STOP””button or by
automatic power off after 3 minutes.
5.1 View Past Readings
1 Press the “MEM”button to enter memory function,
2 First press the “MEM”button to display the“ AVG“ of last 3 values.second press to the
“MEM”button will display first sets of value and so on.
3 This can stored up to 99 sets of past readings.
5.2 Delete Past Readings
When the monitor’s power is off,press and hold the memory button”MEM”for 5 seconds
until the memory icon “ⓜ”appears in the display .Without releasing the memory
button,press the power button“START/STOP” and “EE EE” will appear.Release the power
button “START/STOP” and the memory button.”MEM” to erase all stored readings from
the monitor.
6.Troubleshooting
Problem Cause Solution
No display when you
press the Power /Start
button
Have the batteries run out? Charging with power adapter
“Reset “button close Press reset button
“Er P” displayed Fail to inflate Check if the cuff is properly
connected.Replace the air
tube if it is broken.
“Er 1” displayed Deflate too rapidly Return for servicing.
“Er 2” displayed Movement during measurement Do not move during
measurement
Signal interference Remove interfering source
e,g. mobile phones,magnets.
“Er 3” displayed Incorrect results Measure again
Note: If your problem cannot be solved by the above,consult your store of
purchase.Do not disassemble the unit.
7. Storage & Maintenance
 Keep away the unit from direct sunlight,extreme temperatures,humidity or moisture.
 Use a dry,soft cloth to clean the unit,or if desired,use a cloth lightly dampened with
water.