Installation & Assembly

(1)

Assembly Of Drawers : 3 DRAWERS

DRAWER G

(2)

(3)

Insert the minifix⑤

(nuts) with the cross

arrow mark facing downward and aim to

panel H and I 's lower thru holes. (As shown)

Insert the PVC dowels ⑥ to end of the

panels H to I. Using hammer to gently tap

them in.

Place panels H and I on each side of panel J

as shown.

Then tighten screw ② to panels H and I 's

upper thru holes to fix them onto panel J.

Insert, push down and tighten mini fix screw ⑤, to the

non-thru hole as shown, 4pcs.

Inserting panels H and I 's lower PVC dowels onto the

center non-thru holes at panel G.

Then, tighten mini fix ⑤

(nuts) clockwise to lock the mini fix

up for tightening panel H and I to panel G. Cover 4 mini fix

caps provided by pushing the cover 's stem onto the hole

of mini fix nut on lower side of panel H and I.

Flip drawer with bottom side up, place panel

K onto panels H, I and J and insert panel K

to groove of panel G.

Then nail the nails⑧ provided with hammer on the

border of panel K as shown.The gap between 2 nails

should be about 100mm.

After that, place drawer slides B ⑫ with the small white

roller facing outward and with other end tip touching

panel G onto each bottom side (angle) edge of panels H

and I.

Then tighten 3 screws ③ on each drawer slide B ⑫ (as

shown).

Insert the pvc dowels ⑥ to end of the panel L. Using

hammer to gently tap them in.

Place and fix panel L onto panel G by inserting the dowels

onto the non-thru holes at panel G.

Then tighten screw ② to panels L 's thru holes to fix them

onto panels K and J.

(4)