Installation & Assembly

Hardware may loosen over time. Periodically check that all connections are tight.
Assembly is complete. The bed frame is ready to use now!
Place the Roll Slats (6) to the Long Board (2) as shown.
Secure 4 pieces of Roll Slats (6) which have countersink holes on each end into the Long Board (2) by using
8 pieces of Screw (B) as shown.
Tighten the Screws (B) with Philips Head Screw Driver (not provided).
Secure 4 pieces of Screw (B) into the Slat (6) on the top of Center Rail (3) as shown.
Tighten the Screws (B) with Phillips Head Screw Driver (not provided).
Attention: Please adjust the adjustable glide on the Support Leg (4) once the bed is unlevel.
B
B
B x 8
B x 4