Before you start, here are some helpful advice: Components: Short Board x2 Supprot Legs x4 Long Board Legs x2 x4 Center Rail Roll Slats x1 x13
Secure the 2 pieces of Wooden Leg (5) to the Short Board (1) as shown. Repeat the same steps for the remaining 1 piece of Short Board (1). Tighten the Leg (5) clockwise until secure. Place 1 piece of Long Board (2) to the assembled 2 pieces Short Board (1) by two adults. Attach them by using 4 pieces of Bolt (A) as shown. Use Allen Wrench (C) to tighten the Bolts (A) clockwise until secure. Repeat the same steps for the remaining 1 piece of Long Board (2).
Secure 4 pieces of Support Leg (4) to the Center Rail (3) with pre-set T-nut as shown. Tighten the Support leg (4) clockwise until secure. Insert Center Rail (3) to the bracket (provided) on Short Board (1) and then secure with 1 piece Screw (B) per each end. Tighten the Screw (B) with Phillips Head Screw Driver (not provided).
Place the Roll Slats (6) to the Long Board (2) as shown. Secure 4 pieces of Roll Slats (6) which have countersink holes on each end into the Long Board (2) by using 8 pieces of Screw (B) as shown. Tighten the Screws (B) with Philips Head Screw Driver (not provided). B Bx8 Secure 4 pieces of Screw (B) into the Slat (6) on the top of Center Rail (3) as shown. Tighten the Screws (B) with Phillips Head Screw Driver (not provided).
CONNECTING BED FRAME TO HEADBOARD Reminder: All the hardware packed in the Headboard you bought. Please use only the above hardware from Haedboard Hardware Package to assemble the Bed Frame and Headboard.
CONNECTING BED FRAME TO HEADBOARD
