Installation & Assembly

Place

G x 12

H x 12 D x 1

I x 12

Hardware & Tool required

STEP 1 :

Place Mattress Panel (3) and Legs (2) on a carpeted or padded area as shown. Attach Legs (2) into Mattress Panel L & R (3) by

inserting JCBC SCREW M6 x 40mm(G),Spring Washer

''(H) and Flat washer

'' (I).Tighten with M4 Allen Key (Ball Shape)Long(D).

STEP 2 :

1. Secure the Wooden Support(4) by using Bolt Base Glide M6 x 23(C83)(E).Insert the wooden dowels into the bottom holes

on each side of the

Wooden Support(4).

2. Attach Wooden Support(4) first by inserting the other end of the Wooden Dowels(J) into the corresponding holes on the

Mattress Panel (3),and then secure by inserting JCBC Screw M6 x 35mm(F),Spring Washer

''(H) and Flat Washer

''(I).

Then,tighten with M4 Allen Key(Ball Shape)Long(D).

F x 2 H x 2

I x 2

Hardware & Tool required

E x 2

Page 2/3

J x 2