Installation & Assembly

Step 3
Step 4
Step 5
Place the Chair facedown onto a clean, non-marring surface as shown in
picture.
Put the Dust Cover back on the bottom of the Chair by smoothing down
the velcro at all four edges by hand.
Your Club Chair is ready for use.
This Club Chair can only be used on a flat, level surface.
Place the Chair on a LEVEL SURFACE to check for wobbles.
If it wobbles, press firmly down on both armrests at the same time. This
will help to ensure all Bolts and gaps reach full alignment status.
If no wobbles found, proceed to tighten all Bolts at all joints.
DO NOT fully tighten a Bolt in one go and then move on to the next.
Rather, in a sequential manner, gradually tighten each Bolt until all
Bolts are evenly secured.
This methodology will ensure maximum eveness once all Bolts are
fully tightened.
Page 5 OF 6