Caution : You must read this before you proceed Club Chair Page 1 OF 6
Label Description QTY A Chair 1 B Right Front Leg 1 C Left Front Leg 1 D Back Leg 2 Description QTY ① Bolt (M8*60MM) 9 ② Spring Washer 9 ③ Washer 9 ④ Allen Key 1 Label Picture Picture Page 2 OF 6
Before Beginning Assembly: Chair(A) Back Leg(D) Right Front Leg(B) Left Front Leg(C) FRONT FACING Page 3 OF 6
This Club Chair has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Club Chair parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 X9 X9 X9 Place the Seat(A) on a clean, non-marring surface with the bottom facing you, as shown in the picture above.
Step 3 Place the Chair on a LEVEL SURFACE to check for wobbles. If it wobbles, press firmly down on both armrests at the same time. This will help to ensure all Bolts and gaps reach full alignment status. If no wobbles found, proceed to tighten all Bolts at all joints. DO NOT fully tighten a Bolt in one go and then move on to the next. Rather, in a sequential manner, gradually tighten each Bolt until all Bolts are evenly secured.
Page 6 OF 6
