User's Manual

TRUE RESIDENTIAL
®
TEC_TM_102 REV. B02/02/2022Page 40 of 74
CABINET SETUP
Shelf
Clip
Shelf
Shelf
Pillaster
(I-beam)
Shelf
Standards
PROCEDURE
1. Hook the shelf clips into the shelf standards.
See fig. 1.
2. Push up on the bottom of the clip. See fig. 2.
NOTE: YOU MAY NEED TO SQUEEZE OR
TWIST THE BOTTOM OF THE SHELF CLIP
FOR PROPER INSTALLATION. POSITION ALL
FOUR SHELF CLIPS EQUAL IN DISTANCE
FROM THE FLOOR FOR FLAT SHELVES.
3. Ensure the shelf clip is not loose or able to wiggle
out of the shelf standard. See figs. 3 and 4.
4. Place the shelves on the shelf clips with the cross
support bars facing down.
NOTE: BE SURE ALL SHELF CORNERS ARE
PROPERLY SEATED.
INSTALLATION TIPS
• Install all the shelf clips before installing any
shelves.
• Start at the bottom shelf and work your way up.
• Always lay the back of each shelf down on the
rear clips before the front.
WARNING – DO NOT USE
PLIERS OR ANY CRIMPING
TOOLS WHEN INSTALLING
SHELF CLIPS. ALTERING
SHELF CLIPS IN ANY WAY
CAN LEAD TO SHELVING
INSTABILITY.
SHELF INSTALLATION
FIG. 1. Installing top tab of
shelf clip.
FIG. 2. The bottom tab of the
shelf clip will fit tightly
FIG. 3. You may need to squeeze
or twist the bottom of the shelf
clip to install.
FIG. 4. Installed shelf clip.