User's Manual

TRUE RESIDENTIAL

TEC_TM_102 REV. B02/02/2022Page 34 of 74

UNCRATING

REQUIRED TOOLS

Required tools include (but may not be limited to) the

following:

• Cutting Tool

• Hammer

• Crowbar

• Phillips Screwdriver

• Floor Protector

PROCEDURE

The following procedure is recommended for uncrating

the unit:

1. Remove the outer packaging (cardboard and clear

plastic). See fig. 1. Inspect for concealed damage.

Again, immediately ﬁle a claim with the freight carrier

if there is damage.

2. Cut the plastic band and remove the Styrofoam

block. See fig. 2.

NOTE: MOVE THE UNIT AS CLOSE AS

POSSIBLE TO ITS FINAL LOCATION BEFORE

REMOVING THE SKID.

3. Position the floor protector next to the skid.

4. Carefully lift the unit off the skid and place the unit

on the floor protector.

NOTE: DO NOT LIFT THE CABINET BY THE

COUNTERTOPS, DOORS, DRAWERS, OR

GRILLS.

5. Remove the interior packaging.

NOTE: KEYS FOR THE UNIT ARE INSIDE

THIS PACKET.

6. If applicable, remove the wire shelving, shelf clips,

and/or floor wine cradle packed on top of the unit.

For shelving installation instructions, see page 24.

INSTALLATION

FIG. 1.

Pull the cardboard from the pallet.

FIG. 2.

Remove the foam block after moving the unit

as close as possible to the final installation location.