User's Manual

TRUE RESIDENTIAL
®
TEC_TM_070 REV. B02/03/2021Page 36 of 74
BEER TAP CLEANING KIT
REQUIRED TOOLS
2
BLC SYSTEM
CLEANER
SPANNER
WRENCH
BRUSH
BUCKET AND
FRESH WATER
PUMP BOTTLE
AND TUBE
RUBBER
GASKET
RUBBER
GASKET
3
1
CLEANING INSTRUCTIONS FOR DRAFT TOWERS
Draught dispensers, regardless of design, must be
cleaned on a regular basis. Flushing your draught
dispenser with water only is not enough. Cleaning is
recommended whenever changing to a fresh keg.
NOTE: USE CLEANERS APPROVED BY YOUR BEER
SUPPLIER AND FOLLOW THEIR INSTRUCTIONS. IF
YOU ARE USING THE CLEANING KIT PURCHASED
FROM TRUE FOLLOW THESE INSTRUCTIONS:
Cleanliness should be constantly maintained in your
dispenser so that your draught beer will be at its best
when served. Although the beer in the barrel is in
excellent condition, it can become less satisfying as it
is drawn through the beer line and faucet if they are
not kept clean.
Prepare Solution:
Add 1/2 ounce (19 grams) of cleaning solution to each
quart of warm water. Fill pump bottle with the mixed
cleaning solution.
Beer Cleaning instructions:
1. Shut-off the CO
2
at the regulator.
2. Remove the tapping device (keg coupler) from the
keg.
3. Unscrew handle from faucet.
4. Remove beer faucet with spanner wrench (turn
clockwise to remove). (image 1).
5. Put tap and faucet parts in a bucket.
6. Thread hose from pump bottle to beer column tap
outlet (be sure rubber gasket is in place to prevent
leakage) – allow beer line to drain in bucket.
(Image 2).
7. Pump solution from bottle through the beer line(s)
into the bucket. Wait 10 minutes while cleaning
solution works through the lines.
8. Use supplied brush to clean beer faucet parts.
(Image 3).
9. Rinse parts thoroughly.
10. Rinse bucket, pump bottle and hose thoroughly
with clean cool water.
11. Fill pump bottle with clean cool water and pump
through lines until water runs clear. (repeat if
necessary)
12. When crystal clear water comes through, you’re
ready to assemble and reattach faucet and re-tap
the keg.