Use and Care

............ www.truemfg.com ............
True Food Service Equipment, Inc.
8
8
Step 1 - Position Cabinet
Allowoneinchbetweenthewallandrearofthe
refrigeratedBarEquipmenttoassureproperventilation.
ForGlass&PlateChillers/Frosters3inchesbetweenthe
wallandrearofthecabinetwillassureproperventilation.
Step 2 - Level Cabinet
Cabinetshouldbelevel,sidetosideandfronttoback.
Placeacarpenter’slevelintheinteriorfloorinfour
places:
A. Positionlevelintheinsideflooroftheunitnearthe
 doors.(Levelshouldbeparalleltocabinetfront).
 Levelcabinet.
B. Positionlevelattheinsiderearofcabinet.(Again
 levelshouldbeplacedparalleltocabinetback).
C. PerformsimilarprocedurestostepsA&Bbyplacing
 theleveloninsidefloor(leftandrightsides-parallel
 tothedepthofthecooler).Levelcabinet.
Step 3
Drawanoutlineonthebaseonthefloor.
Step 4
Raiseandblockthefrontsideofthecabinet.
Step 5
Applyabeadof“NSFApprovedSealant”,(seelistbelow),
toflooronhalfinchinsidetheoutlinedrawn.Thebead
mustbeheavyenoughtosealtheentirecabinetsurface
whenitisdownonthesealant.
Step 6
Raiseandblocktherearofthecabinet
Step 7
ApplysealantonfloorasoutlinedinStep5onother
threesides.
Step 8
Examinetoseethatcabinetissealedtoflooraround
entireperimeter.
Note:
Asphaltfloorsareverysusceptibletochemicalattack.A
layeroftapeonthefloorpriortoapplyingthesealant
willprotectthefloor.
NSF Approved Sealants:
1.MinnesotaMining#ECU800Caulk
2.MinnesotaMining#ECU2185Caulk
3.MinnesotaMining#ECU1055Bead
4.MinnesotaMining#ECU1202Bead
5.ArmstrongCork-RubberCaulk
6.ProductsResearchCo.#5000RubberCaulk
7.G.E.SiliconeSealer
8.DowCorningSiliconeSealer
SEALING CABINET TO FLOOR
INSTALLATION / OPERATION INSTRUCTIONS