Use and Care

............ www.truemfg.com ............
INSTALLATION / OPERATION INSTRUCTIONS
True Food Service Equipment, Inc.
5
5
TOOLS REQUIRED:
• Phillipsscrewdriver
• 3/8”socketor3/8”wrench
A. Useaphillipsscrewdiverandremovefourscrews
fromtheL-bracketconnectedtheunittothewood
skid(seeimage1).Thenusea3/8”socketorwrench
andremovetheL-bracketfromtheunit
(seeimage2).
When lifting unit do not use the countertop as
a lifting point. Also remember to leave cabinet upright
for 24 hours before plugging into power source.
B. Removeskidbyunscrewingallbaserailanchor
brackets.Placeskidtotheside.
C. Carefullyuprightcabinet.
D. Applicancetestedaccordingtotheclimateclasses5
and7fortemperatureandrelativehumidity.
LOCATING
Removing
bracket from
skid.
Removing bracket
from cabinet.
1
2
A. Setunitinitsfinallocation.Besurethereisadequate
ventilationinyourroom.Underextremeheat
conditions,(100°F+,38°C+),
youmaywanttoinstallanexhaustfan.
WARNING
Warranty is void if ventilation is insufficient.
B. ProperlevelingofyourTRUEcooleriscriticalto
operatingsuccess(fornon-mobilemodels).Effective
condensateremovalanddooroperationwillbe
effectedbyleveling.
C. Thecoolershouldbeleveledfronttoback
andsidetosidewithalevel.
D. Ensurethatthedrainhoseorhosesarepositionedin
thepan.
E. Freeplugandcordfrominsidethelowerrear
ofthecooler(donotplugin).
F. Theunitshouldbeplacedcloseenoughtothe
electricalsupplysothatextensioncordsarenever
used.
WARNING
Cabinet warranties are void if OEM power cord is tampered
with. True will not warranty any units that are connected to
an extension cord.
LEVELING
Theseinstructionsexplainhowtokeepdoorinopen
position.
A. Slidethedooropen.
B. Latchthedoorintheopenpositionfromthe
backsideofdoor(notchintrack).
C. Doorlatchinimage1isintheopenposition.
D. Doorlatchinimage2isintheclosedposition.
SLIDE DOOR UNITS WITH HOLD OPEN FEATURE
1
2
(Rear view of door & track)