Spec Series Manual

LAE Electronic Control

Info/Set Point

Button

Manual Defrost/

Down Button

Manual Activation/

Up Button

Stand-By

Button

SETTING TIME OF DAY

WHY:

TO MAKE SURE THE CABINET DOES NOT INITIATE

DEFROST & GET WARM DURING TIMES OF HIGH USAGE.

Control may be designed to initiate defrost at speciﬁ c

times of the day.

HOW:

A. To change the time of day, press and release the info

button . “t1” will appear.

Press the up button until “min” appears.

See image 1.

B. While pressing and holding the info button ,

press the up or down button to change the

clock minutes. See image 2.

C. Once the minutes have been set correctly, release the

info button and “hrs” will appear on the display.

See image 3.

D. While pressing and holding the info button ,

press the up or down button to change the

clock hours. See image 4.

Note: When changing the clock hour, the clock will be

displayed in 24 hour format ranging from 0-23.

E. Once the hour has been set correctly, release the info

button .

Wait 5 seconds for the display to show temperature.

See image 5.

press the up or down button to change the

Press the up button until “min” appears.

press the up or down button to change the

button . “t1” will appear.

While pressing and holding the info button ,

button .

While pressing and holding the info button ,

info button and “hrs” will appear on the display.

May need to unlock control. Does not adjust for daylight savings time.

This is only necessary if the defrost mode parameter (DFM) is set for “RTC”.