Spec Series Manual

19
STR•STA
•STG
DOOR OPERATION
Door Configuration:
After installing, cabinet doors can be
adjusted for alignment. The hinge on
the door and hinge on the cabinet can
be adjusted accordingly.
Step 1
To remove door open at a 90˚ angle
from the cabinet and lift door up and
out from the cabinet hinges carefully
avoiding rainshield. Rest the door in a
safe area.
Step 2
Remove gray plastic cover from hinge
located on the cabinet. (See image 1).
Use a standard screw driver and pry out
the gray cover. This exposes the three
Phillips screw anchoring the hinge to
the cabinet. (See image 2). Loosen
these three screws but don’t remove
them. Adjustment can be made slightly
up/down and side to side.
Step 3
The hinge on the cabinet door can also
be adjusted. Remove cover from hinge
located on the door. Pull on the cover
directly out from the door. (See image
3). This exposes the three Phillips
screws anchoring the hinge to the door.
Loosen these three screws but don’t
remove them. The hinge can be
moved side to side, up and down. (See
image 4).
NOTE:
When tightening the hinges to
the cabinet and door do not
apply pressure to the Phillips
screws. Carefully anchor them
without applying extreme
amounts of pressure.
Step 4
To adjust the lock latch remove two
Phillips screws and the latch can be put
to the side for later reinstallation. (See
image 5). The lock base that anchors
the latch can be adjusted simply by
loosening the two Phillips screws, but
not removing them. Then the lock base
can be moved side to side for
adjustment. (See image 6). After
adjustment is complete tighten the lock
base and install the latch back into
place.
Image 1
Image 2
Image 3
Image 4
Image 5
Image 6