Spec Series Manual

17
STR•STA
•STG
TRUE STR, STA, and STG cabinets are available with four
different shelving / tray slide options.
Type Kit #1. Angle Type Tray Slide
Type Kit #2. Rod Style Tray Slide
Type Kit #3. Universal Tray Slide
Type Kit #4. Shelf Standards (shelf clips)
Required Tools:
• Standard Screwdriver (Flathead)
• Rubber / Plastic Mallet
• Tape Measure
Installation Procedures (Wire Shelves):
Wire shelves come with shelf clips (image 1).
Properly insert the shelf clips in the desired height (remember
all shelf clips will need to be installed at the same height to
keep the shelf level.
Once the shelves are installed the remaining threaded holes
will have thumb screws inserted. These thumb screws are
provided in the unit.
PILASTER INSTALLATION & OPERATION
NOTE:
The package containing the pilasters will have the same serial number as cooler.
Please check to make sure these serial numbers are the same.
Type Kit #1 (Angle Type Tray Slide)
Type Kit #2 (Rod Style Tray Slide)
Type Kit #3 (Universal Tray Slide)
Shelf
Shelf
Standards
Shelf
Clip
Shelf
WARNING
Do not use pliers or any
crimping tools when installing
shelf clips. Altering shelf
clips in any way can lead to
shelving instability.
Install the top tab of the
shelf clip into the proper
hole. Push up on the
bottom of the clip. Bottom
tab of the shelf clip will t
tightly. You may need to
squeeze or twist the bottom
of the shelf clip to install
.
Image 1
Type Kit #4
(Shelf Standards
/ Shelf Clips)
Image 2
Image 3
Image 4
Image 5
Image 6
Image 7