Use and Care

8
True
glass door merchandisers
www
.truemfg.com
SEAlING CAbINET TO flOOR
STEp 1 - Position Cabinet - Allow one inch between the wall and
rear of the GDM refrigerator to assure proper ventilation. For GDM
freezers3inchesbetweenthewallandrearofthecabinetwillassure
proper ventilation.
STEp 2 - LevelCabinet - Cabinet should be level, side to side and
front to back. Place a carpenter’s level in the interior floor in four
places:
A. Position level in the inside floor of the unit near the doors.
(Levelshouldbeparalleltocabinetfront).Levelcabinet.
B. Position level at the inside rear of cabinet. (Again level should
be placed parallel to cabinet back).
C. Perform similar procedures to steps A & B by placing the level
on inside floor (left and right sides - parallel to the depth of the
cooler).Levelcabinet.
STEp 3 - Draw an outline on the base on the floor.
STEp 4 - Raise and block the front side of the cabinet.
STEp 5-Applyabeadof“NSFApprovedSealant”,(seelistbelow),
to floor on half inch inside the outline drawn. The bead must be heavy
enough to seal the entire cabinet surface when it is down on the
sealant.
STEp 6 - Raise and block the rear of the cabinet
STEp 7 - Apply sealant on floor as outlined in Step 5 on other
three sides.
STEp 8 - Examine to see that cabinet is sealed to floor around
entire perimeter.
NOTE: Asphalt floors are very susceptible to chemical attack. A
layer of tape on the floor prior to applying the sealant will protect
the floor.
NSf AppROVEd SEAlANTS:
1. Minnesota Mining #ECU800 Caulk
2.MinnesotaMining#ECU2185Caulk
3.MinnesotaMining#ECU1055Bead
4. Minnesota Mining #ECU1202 Bead
5.ArmstrongCork-RubberCaulk
6.ProductsResearchCo.#5000RubberCaulk
7.G.E.SiliconeSealer
8. Dow Corning Silicone Sealer