Use and Care

29
True
glass door merchandisers
www
.truemfg.com
ClEANING THE CONdENSER COIl
When using electrical appliances, basic safety precautions should be
followed, including the following:
TOOlS REqUIREd
STEp 1 - Disconnect power to unit.
STEp 2
SLIDEDOORMODELS:
Remove louver grill by removing
Phillips screw located on either
side of the louver grill. (See image
1). Pull the louver grill out from
the cabinet front. (See image 2).
(To reinstall grill, place louver grill
back into brackets located at the
base of the unit (See image 3).
Snap top of louver grill into place.
Replace screws).
SWINGDOORMODELS:
Take off lower grill assembly by removing four (4) screws.
(Seeimages4&5.)
• PhillipsScrewdriver
• StiffBristleBrush
• AdjustableWrench
• AirTankorCO2Tank
• VacuumCleaner
STEp 3 - Remove bolts anchoring compressor assembly to frame
rails and carefully slide out. (tube connections are flexible)
STEp 4 - Clean off accumulated dirt from condensing coil with a
stiff bristle brush.
STEp 5-Liftcardboardcoverabovefanatplasticplugsandcarefully
clean condenser coil and fan blades.
STEp 6
INDOORLOCATION:
After brushing condenser coil vacuum dirt from coil, and interior
floor.
OUTDOORLOCATION:
(GDM-33, GDM-47, and GDM-49 only)After brushing condenser
coil blow CO
2
through condenser from fin side to fan.
STEp 7 - Replace cardboard cover. Carefully slide compressor
assembly back into position and replace bolts.
STEp 8 - Reinstall louver assembly onto unit with appropriate fas-
teners and clips. Tighten all screws.
STEp 9 - Connect unit to power and check to see if condenser is
running.
IndoorLocation
OutdoorLocation
1
2
3
4
Loosenbutdonotremove
4 Phillips screws inside the
grill frame.
Liftthegrillupuntilitclearsthe
screw key hole slots.
5
MAINTENANCE, CARE, ClEANING