Use and Care

12
True
glass door merchandisers
www
.truemfg.com
STEp 5 - Slide left door to the right so right edge lines up with the
end of theTRUE Logo located at the top of the door frame. See
image 6. Then lift door out of track same way as image 4.
(ThreeDoorUnitsONLY)
TRUELogo
6
NOTE: Door cord will either be nylon cord or metal cable.
STEp 6 - Remove door cord from roller bracket. The black plastic
tabholdingthedoorcordslidesouttheback.Seeimages7&8.
10
7
Door roller bracket with metal cable.
8
Door roller bracket with nylon cord.
9
Door closing to the left
STEp 8 - When reinstalling door, make sure door cord grommet
attaches to roller slot closest to pulley. See image 9.
STEp 7-Letthedoorcordslowlyretractbackintothedoorside
channel.
TO AdJUST SlIdE dOOR
STEp 1 - After cabinet is installed in a final location and correctly lev-
eled check for any openings when the slide doors are completely closed.
If there are any gaps/openings between the closed doors and cabinet,
the doors will need to be adjusted.
STEp 2-Usinga7/16"wrenchoradjustablewrenchand1/8"Allen
wrench loosen roller and move along slotted hole. After adjustment
has been made tighten the roller into place. See image 10.
SlIdE dOOR UNITS WITH HOld OpEN fEATURE
These instructions explain how to keep door in open position.
A. Slide the door open.
B. Latchthedoorintheopenpositionfromthebacksideofdoor
(notch in track).
C. Door latch in image 1 is in the open position.
D. Door latch in image 2 is in the closed position.
Rear view of door & track
1 2