Owner's Manual

CHAPTER 2: ASSEMBLY INSTRUCTIONS
ELLIPTICAL ASSEMBLY STEPS (continued):
Step 7: Attach Side Rails:
a)
Install each side rail with two M12
bolts (10 mm hex key) at the bottom and
with two M8 bolts (6mm hex key) at the
top as shown in Fig 7.
NOTE: Side rails are marked “L” for Left
and “R” for Right. Side Rails should flair
out from center of machine if installed
correctly.
Hardware Required:
4 M8 x 1.25 x 12 Bolts
4 M12 x 1.75 x 25 Bolts
Step 8: Attach Bottle Holders:
a) Attach water bottle holders as shown.
NOTE: Water Bottle Holders are
marked “L” for Left and “R” for Right.
b) Place M8 bolt through water bottle
holder, then through spacer and then
install into side rail as shown.
c) Tighten bolts with 6 mm hex key.
Hardware Required:
4 M8 x 1.25 x 20 bolts
4 Spacers
Place M8 bolt through
bottle holder then
through spacer
Truefitness.com / 800.426.6570 / 636.272.7100 12