Owner's Manual

CHAPTER 2: ASSEMBLY INSTRUCTIONS
ELLIPTICAL ASSEMBLY STEPS (continued):
Step 1: Secure Left Pedal Link:
a
)
Important:
With machine still on
pallet, attach left pedal linkage to
crankshaft as shown.
b) Secure with four M8 bolts using 6mm
hex key. Use ball end of hex key for
bottom screw.
c) Once linkage is attached, carefully
remove unit from pallet.
Hardware Required:
4 M8 x 1.25 x 12 Bolts
Step 2: Attach Upper Body Exercise Arms:
a) Note upper arms are labeled “L” for
Left and “R” for Right.
b) Install each upper arm with two M12
bolts using a 10 mm hex key.
Hardware Required:
4 M12 x 1.75 x 25 Bolts
Truefitness.com / 800.426.6570 / 636.272.7100 9