stand desk PRODUCT GUIDE & ASSEMBLY INSTRUCTIONS
Should you prefer to speak with a customer service representative, you may call toll free: 1-855-372-2315 2
Guidelines FAILURE TO FOLLOW THESE WARNINGS WHEN IN USE COULD RESULT IN INJURY • Do not stand on the item or use as a step ladder • Do not use this item unless all bolts and screws are firmly secured and fastened. • Check all bolts and screws every 90 days. As necessary tighten if any are loose. • Lift up then move. Pushing over or dragging this product can result in an injury or cause damage to the Floor and piece.
WARNING: DO NOT LET CHILDREN PLAY IN OR AROUND THE UNIT DUE TO THE POSSIBLE RISK OF INJURY. Pre-Assembly Preparation: Please read through this instruction booklet before beginning assembly of this item. Two adults are recommended for assembly. • Clear out the space for assembly and lay out all parts on Parts List, extra room will allow you to easily determine if all the pieces are present. • Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or hardware.
Parts List A Desk (1) D Accessory (1) B Key Board (1) C Accessory (4) 5
Step 1 1. Ensure all parts have been removed from the carton and place on a protected surface or carpet. 2. Check all parts and hardware are the same as the “Parts List”. + Please take the packaging apart, take out the product and place it one the table Please place the product properly according to its size, or it may At t en t io n harm or cause damage.
Step 2 7
Step 3 Based on the actual usage, press the handle on one side, and adjust the workstation to the proper height War n in g 8 Please do not put hands near the supporting bars, as they change during adjusting and may hurt you.
Accessory guide Please make sure all installed equipments are on the table, and not sticking out of the edge, or it may harm or cause damage. Please put the devices onto the top of the workstation. This surface is with glue, helping to fix the cable management on the table Nylon ties Bundle the cables with hook and loop strip. Cable Adhesive buckle helps to make the cables tidy and clean. Please leave enough length of cable for height adjustment function, otherwise it may cause unexpected damage.
Technical data Max 33 lb. 5-1/2 ~ 19-3/4” 26-3/4” 23-1/ 4” 12-5/ 8” 23-1/ 8” Max 4.4 lb. 20-1/2” Table cover size: > 25-5/8” >23-5/8” WARNING 10 Please do not exceed the maximum WARNING bearing weight Loading range 0 ~ 33 lb.
Warning 11
Product Dimension 26-3/4" 23-1/4 " 12-5/8 5-1/2~19-3/4" " 25-7/8" 23-1/8 " 12 20-1/2"
Limited Warranty The manufacturers products are warrantied against defects in material and workmanship while owned by the “Original Purchaser”. The term “Original Purchaser” is defined as the party or entity which purchases this manufacturer’s furniture from an authorized retailer as shown by the original sales receipt. This warranty does not apply to “as is” or previously owned products.
