Install Guide and User's Manual

5
15 INCH & 24 INCH INSTALL GUIDE
packing material
TOE KICK IS ATTACHED
TO BACK OF UNIT
UNCRATING
Required Tools:
• Cutting utensil (utility knife)
• Hammer
• Crowbar
• Phillips head screwdriver
The following procedure is recommended for
uncrating the unit:
MOVE YOUR UNIT AS CLOSE TO THE FINAL
LOCATION AS POSSIBLE BEFORE REMOVING THE
WOODEN SKID.
A. Remove nails securing cardboard box to the
wooden skid. Then discard any outer packaging
(cardboard, clear plastic).
INSPECT FOR CONCEALED DAMAGE. AGAIN,
IMMEDIATELY FILE A CLAIM WITH THE FREIGHT
CARRIER IF THERE IS DAMAGE.
B. IMPORTANT: Cut green polyband and remove
styrofoam block before removing refrigerator from
pallet.
C. Remove skid by carefully lifting the refrigerator off
and place skid aside.
D. Open the unit and remove any packing material.
Styrofoam, tape, and any other material used
for shipping purposes.
NOTE: KEYS FOR UNIT ARE PROVIDED WITH
THIS PACKET.
NOTE: ANTI-TIP KIT AND DOOR STOP ARE PACKED
INSIDE UNIT.
A B
C D