Install Guide and User's Manual

TRUE RESIDENTIAL

DRAWER OVERLAY PANEL INSTALLATION

Required Tools:

• Phillips Screwdriver

• 1/8" Drill Bit

SEE PAGE 21 FOR OVERLAY PANEL DIMENSIONS

BEFORE INSTALLING.

FOR EASY OVERLAY INSTALLATION, DRAWER FRONT

REMOVAL IS REQUIRED.

1. Open the drawer and detach the front drawer panel

by removing four #2 Phillips screws (two on each

side). (See image 1). Save all these screws for later

reinstallation.

2. Remove front drawer panel gasket.

3. Using a 1/8" drill bit, drill out the eight pilot holes

(each drawer) from the front of the drawer panel.

Drill completely through the panel.

4. Attach drawer handle to the front of the overlay

panel. Attach handle before step 5.

5. Lay overlay panel face-down on a safe solid

surface. Lay drawer panel face-down on top of

the overlay panel. Align panels and secure with a

clamp. Lay cardboard or other soft or safe material

down before working on drawer front.

6. Secure overlay panel to drawer panel using

appropriate size screws.

7. Reattach drawer gasket by pressing and snapping

back into place in gasket channel.

8. Reattach drawer panel front to the drawer using

four screws.

Front of

drawer