TUI15 Installation Guide

31
15 INCH ICE MAKER INSTALL GUIDE
WATER SHUTTERS
ICE CHUTE
CLAMP
CAP
WATER SHUTTERS
Water shutters prevent spraying water from
escaping the evaporator compartment.
Removing water shutters for cleaning:
1. Lift shutter shaft out of recesses on either
end of shaft.
2. To reinstall, insert ends of shaft into
recesses above either side of evaporator
compartment opening.
ICE CHUTE
The ice chute is seated over the spray nozzles
and allows ice to fall into the bin. It must be
firmly positioned over the spray bar, with the front
edge inside the water trough. Spray nozzles must
align with the slots in the ice chute or spray water
will fall into the bin.
1. Grab chute and lift up to remove.
2. To reinstall ice chute, grab chute and position
over water spray nozzles. Make sure front
edge is inside of water trough.
PUMP CLEAN-OUT CAP
1. Remove clamp.
2. Pull down clean-out cap.
3. To reinstall, slide cap over hole
underneath pump. Replace clamp.