TUI15 Installation Guide

21
15 INCH ICE MAKER INSTALL GUIDE
DRAIN CONNECTION
The True Ice™ machine has a built-in drain pump that
will pump water up to a drain point, such as a sink.
• Eight feet of 3/8" OD plastic tubing is supplied
with the ice machine.
• The drain pump has a maximum rise of eight feet
(2.4 m) and a maximum run of 100 feet (33 m).
If higher than eight feet, an optional pump may be
required.
• The floor drain must be large enough to
accommodate drainage from all drain lines.
• The drain pump discharge line must terminate at
an open site drain.
WATER FILTER
The built-in water filter is designed to filter sediment,
remove unpleasant taste and odor and inhibit scale.
The life expectancy of the filter is twelve months for
low scale water and six months if the water has a high
level of scale. The ice machine monitors how long
the filter has been in operation and will display “FLT”
when the filter needs to be replaced. See water filter
replacement instructions on page 33.
Replacement water filters are available through your
True dealer.
CAUTION: INSTALL THE WATER FILTER BEFORE
TURNING ON THE WATER SUPPLY TO THE ICE
MACHINE.
CAUTION: DO NOT ALLOW THE ICE MACHINE TO
BE EXPOSED TO TEMPERATURES BELOW 32°F
(0°C) AS THIS WILL CAUSE ANY WATER IN THE
MACHINE TO FREEZE. FAILURES CAUSED BY
EXPOSURE TO FREEZING TEMPERATURES ARE
NOT COVERED BY THE WARRANTY.
POSITION THE UNIT
Once the unit has been leveled and connected to a
drain, the water supply can be connected and turned
on. The unit can then be plugged in and energized.
Once these steps are complete, slide the unit into
its final desired position, presumably inside the
cabinetry. You should then proceed to the “BEFORE
OPERATING” step on page 25.