TUI15 Installation Guide

15 INCH ICE MAKER INSTALL GUIDE

OVERLAY PANEL INSTALLATION

Required Tools:

•

Phillips Screwdriver

•

3/8" Wrench

•

1/8" Drill Bit

•

Three (3) Screws #6

SEE PAGE 16 FOR OVERLAY PANEL DIMENSIONS

BEFORE INSTALLING.

FOR EASY OVERLAY INSTALLATION, ICE MACHINE

DOOR REMOVAL IS REQUIRED.

1. Open front door and pull kickplate forward

to remove.

2. To remove door, back out two bottom hinge

screws with a 3/8" wrench. Secure door while

removing screws. Remove two Phillips screws

from the top hinge. Save all these screws for later

reinstall.

3. Lay door on a safe solid surface. Lay cardboard

or other safe material down before working on

the door.

4. Remove door gasket from the inside of the door

frame. Place gasket to the side for later reinstall.

5. There are pre-marked areas on the front of the

door. Drill these pre-marked holes with 1/8" drill

bit. Make sure to drill all the way through the

door.

NOTE: IF HANDLE IS BEING USED ON OVERLAY,

INSTALL IT BEFORE STEP 8 (SEE IMAGE A ON

PAGE 22). FOR BEST INSTALLATION, SCREWS

ATTACHING HANDLE SHOULD BE RECESSED.

6. It is recommended to clamp the door front on

top of the overlay before drilling pilot holes and

installing anchor screws. The clamp ensures the

overlay panel and door stay aligned with each

other while installing. Once panel is clamped in

place, pilot holes may be drilled into the panel

from the rear side of the door. Mark to only drill

1/2" into rear side of door.

3 & 4

Remove screws

from top and

bottom hinge