Owner Manual
III. Specificaons & How to Use:
6
To Cancel Timer: While in mer status, press “Timer” key, the digital display shows countdown me. Then press
“+” or “-” key unl the digital display reads “00” and mer display will blink for 10 seconds and then go off. The mer
is no longer acve.
Hot Surface Indicator
After using any of the cooking zones, the cooktop will remain hot. Even after turning o the
entire unit, the surface of the cooktop will remain hot for some time. The display for the cooking
zones will show how an “H” to warn the user that the surface is hot to touch. Wait unl the “H” is no
longer displayed to clean the unit. You may turn the unit back on even if the “H” is displayed.
● This appliance will get hot during use and will remain hot for a me aer use.
● Never heat empty cookware. This can damage both the cookware and the appliance.
● Remember to turn off cooktop aer use.
● Keep unit away from a gas range or other heat source. If the surrounding temperature is too hot, the cooktop will
stop heang.
● Make sure to wipe off water from the boom of the pot before heang.
● Use cauon when boiling water. During the boiling process, hot water may splash out.
IV. Notes on Using your Cooktop
Power Sharing
When both burners are on, one of the two burners would not have a power level higher than level 7. Both of them
together would not be more than level 10. If only one burner is on, the heang zone can maintain its full heat seng,
but when operang both burners, their combined total is level 10, meaning that when operang the two burners at
the same me, they will self adjust levels accordingly. When you increase the power of one side, the power output of
the other side will reduce automacally (i.e. one side is at 6, the other burner automacally reduces
power to level 4, creang a total max 10 seng).
Set Timer Mode
The automac mer sengs range from 1 minute to 99 minutes. (NOTE: there is no “seconds” and “hours”
display, only minutes). when the unit is in the cooking mode press the “Timer” key. The “Timer” indicator light is lit
up, indicang the cooktop has entered Set Timer Mode, the digital display reads “00” and blinking. Press “+” or “-”
key to set the desired number, once the Timer is set and neither the “+” nor the “-” key is pressed for 10 seconds, the
Minute Timer begins the countdown and the mer reaches “00” the cooktop will sound “beep” and the specific
heang element will shut off automacally.