Manual

5
Example application
In this example you will connect an Arduino® board and print sensor values to the
Serial Monitor of the Arduino® IDE.
Connection diagram
The connection diagram uses an Arduino® board to illustrate the wiring.
GND
5V
S
+
–
A0
Example code
Download the example code from www.conrad.com/downloads or scan the QR
code shown. Follow the instructions on the website.
Technical data
Module
Working voltage ....................... 3.3 - 5 V/DC
Signal type ............................... Analog signal
Interface ................................... 2.54 mm pitch 3pin anti-reverse interface
Positioning hole (Ø) ................. 3 mm
Dimensions (L x W x H) ........... 63 x 22 x 9 mm
Weight ..................................... 2.8 g
Wire
Wire length .............................. 200 mm